AERIAL DEVICE

• Versalift Forestry
• VO-260-I Articulated Overcenter Forestry Aerial
• Fully Insulated
• 60’ of platform height
• 65’ of working height
• 51’ of side reach
• Emergency Power

CAB/CHASSIS

• International HV (4×2)
• 35,000lbs GVW
• CA of 138”, Frame Rails Heat Treated Alloy Steel, 120,000PSI Yield 20.1 Section Modulus

FORESTRY PACKAGE

• Forestry Body Painted White
• 132” Long x 60” Tall x 96” Wide
• 6×6 Wrap Around Box with J-Hooks and Shelves – Painted White
• All Locks Keyed Alike
• Inside Ladder & Pruner Pole Box/Curbside
• Tailgate w/270 Degree Swing
• Chipper Air Exhaust Vents
• Undercoated Underneath
• Wheel Chock Holders w/2 Chocks
• Outrigger Pad Holders w/2 Outrigger Pads
• Pintle Hitch with Reinforcement
• Full Cab Guard w/Access Steps Painted Black
• Chip body interior  coated with a coal tar” coating

ELECTRICAL

• LED Lighting
• Back Up Alarm
• Electric Brake Controller
• 6 Pin Round and 7 Flat Trailer Connector
• Add rope lighting to all compartments

WARNING

• 4 amber LED, 4” round warning lights on upper chip body
• Whelen Model #M7AC amber LED flashers shall be positioned as follows:
  • Two (2) on cab grille
  • Two (2) recessed under deck area
  • Two (2) recessed ender chip body side
  • Two (2) on the rear lower bulkhead under rear of chip body

WORK LIGHTING

• Two (2) Fire Tech Hi Viz, 9600 raw lumen work lights shall be installed on the rear of the cab guard
• Two (2) Fire Tech Hi Viz, , 7200 raw lumen work lights shall be installed on the rear, under the boom support to illuminate the hitch and chipper work area

ADDITIONAL and DOT REQUIREMENTS

• Body Harness & Lanyard
• 5lbs ABC Fire Extinguisher
• DOT Triangles
• Stability Tested
• Dielectric Tested
• ICC Bumper
• Mud Flaps
• Stainless Steel “hinged”  SMF Cone Holder on Front Bumper
• Install and Back up Camera System with a 7” Monitor located on the cab dash.
• Supply three (3) 10” rope tie off cleats